Flyfishing, flytying and hooks
Home » Salmon » Green Highlander x 7

Green Highlander x 7

2016-10-18-gh

Green Highlander is one of those patterns that I keep tying, it’s the one that caught my attention when I started out, and I have tied it in different versions the last couple of years (mostly hairwings/polarbear). This winter I have a project to tie up a box of classics for fishing and started gathering material this autumn when the season was over. The final piece that landed in my mailbox was florican and swan, so I set out to tie up 10 GH to get a feel for the pattern.

2016-10-18-gh_wing1

I tied up 3 first, then sat down to do the 7 other in stages; learning a pattern for me means breaking it down into sections: tail & butt, then body with hackle & throat and finally the wing. This way I can focus on one part at the time and repeat it within short timespan to become familiar with that part of the fly.

Here I have completed the body and started laying out the parts to start marrying the wing.

2016-10-18-gh_wing3

Married wing done, then the sides:

2016-10-18-gh_wing4

and finally setting the wing, sides, topping and horns:

2016-10-18-gh_4

With this process I also wanted to try out how different tails made for slightly different expressions (short tail vs. long tail) and how floss body vs. dubbed front-part worked out in the final fly. This is a good exercise if you want to get familiar with a pattern and how it turns out with small differences.

2016-10-18-gh_all

This set was tied on Mustad 80500 #1/0, so the next part will be to tie up on #2/0 and #1 to vary in size when the season starts up again.

2016-10-18-gh_hand

Leave a Reply

Your email address will not be published. Required fields are marked *